Before operating
• ¢ ON
The power turns on and indicator is light.
Set the power switch to this position to turn
the power on and off from the included
remote control unit.
•
£ OFF
The power turns off and power indicator is
off.
In this position, the power cannot be turned
on and off from the remote control unit.
• The front speaker A, B setting can be also be
changed with the SPEAKER button on the
remote control unit.
12
Preparations:
Check that all connections are proper.
(Main unit)
3
Select the front speakers.
Press the SPEAKER A or B button to turn the
speaker on.
(Main unit) (Remote control unit)
1
Press the power switch (button).
When pressed, the power turns on and the
display lights. The sound is muted for several
seconds, after which the unit operates normally.
When pressed again, the power turns off, the
standby mode is set and the display turns off.
(Main unit)
2
Turn on the power.
Press the Power ON/STANDBY switch (button).
(Remote control unit)
• “Punch Through” is a function allowing you to operate the PLAY, STOP, MANUAL SEARCH and AUTO SEARCH
buttons on the CD, TAPE, CDR/MD, DVD/VDP or VCR components when in the DBS/CABLE or TV mode. By
default, nothing is set.
Punch Through
1
Set mode switch 1 to “VIDEO”.
2
4
Input the number of the
component you want to
set. (See Table 1)
Set mode switch 2 to the component to be
registered (DBS/CABLE or TV).
3
Press the DVD/VDP power button and the TV
power button at the same time.
• Indicator flash.
CD
TAPE
CDR/MD
DVD/VDP
VCR
No setting
No.
1
2
3
4
5
0
Table 1
To Next Page
Loading...
Need help?
General
Weight and Dimensions
