20
ENGLISH
1
Simulcast playback
Use this switch to monitor a video source other
than the audio source.
Press the VIDEO SELECT button repeatedly
until the desired source appears on the display.
[4]
Combining the currently playing sound with the desired image
[5] Checking the currently playing program source, etc.
1
Front panel display
• Descriptions of the unit’s operations are also
displayed on the front panel display. In
addition, the display can be switched to
check the unit’s operating status while
playing a source by pressing the STATUS
button.
2
Using the dimmer function
• Use this to change the brightness of the
display.
The display brightness changes in four steps
(bright, medium, dim and off) by pressing
the main unit’s DIMMER button repeatedly.
(Remote control unit)
(Remote control unit)
Cancelling simulcast playback.
• Select “SOURCE” using the video select
button.
• Switch the program source to the
component connected to the video input
jacks.
(Remote control unit)
•To increase the bass or treble: Turn the control
clockwise. (The bass or treble sound can be
increased to up to +12 dB in steps of 2 dB.)
•To decrease the bass or treble: Turn the
control counterclockwise. (The bass or treble
sound can be decreased to up to –12 dB in
steps of 2 dB.)
[1] Adjusting the sound quality (tone)
After starting playback
1
The tone switches as follows each time the
TONE CONTROL button is pressed.
2
With the name of the volume to be adjusted
selected, turn the SELECT knob to adjust the
level.
3
If you do not want the bass and treble to be
adjusted, turn on the tone defeat mode.
The signals do not pass through
the bass and treble adjustment
circuits, so it provides higher
quality sound.
(Main unit)
[2] Listening over headphones
1
Plug the headphones’ plug into the jack.
NOTE:
To prevent hearing loss, do not raise the volume level
excessively when using headphones.
1
Use this to turn off the audio output temporarily.
Press the MUTING button.
[3] Turning the sound off temporarily (muting)
(Main unit)
(Main unit)
(Remote control unit)
Connect the headphones to the PHONES
jack.
The speaker output is automatically turned
off when headphones are connected.
Cancelling MUTING mode.
•Press the MUTING button again.
• Muting will also be cancelled when
MASTER VOL is adjusted up or down.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
