Setting the type of speakers
• Set up in function of your speaker systems. Performing this setup optimizes the system.
• The composition of the signals output to the different channels and the frequency response are adjusted automatically according to the
combination of speakers actually being used.
1
Set whether or not speakers are connected and, if so, their size
parameters.
•To select the speaker
•To select the parameter
2
Press the ENTER or (down) button to enter the settings and switch to the SPEAKER DISTANCE
setting.
• Parameters
Large...................Select this when using speakers that have sufficient performance for reproducing bass sound below the frequency set for
the Crossover Frequency mode.
Small...................Select this when using speakers that do not have sufficient performance for reproducing bass sound below the frequency set
for the Crossover Frequency mode. When this is set, bass sound with a frequency below the frequency set for the Crossover
Frequency mode is sent to the subwoofer.
None……............Select this when no speakers are installed.
Yes/No….............Select “Yes” when a subwoofer is installed, “No” when a subwoofer is not installed.
2spkrs/1spkr .......Set the number of speakers to be used for the surround back channel.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when “Small” is set for the front, center
and surround speakers.
22
ENGLISH
To Next Page
Loading...
Need help?
General
Weight and Dimensions
