7
Preparation
ENGliShDEutSchFrANçAiSitAliANoESpAñolNEDErlANDSSVENSKA
РУССКИЙPOLSKITÜRKÇE
PlaybackSetup Wizard
7
ENGliShDEutSchFrANçAiSitAliANoESpAñolNEDErlANDSSVENSKA
Playback (Basic operation)
Here, we explain how to perform simple operations.
For details, see the included CD-ROM (Owner’s manual).
Important information
Before starting playback, make the connections between the different
devices and the settings on the unit.
NOTE
Also refer to the operating instructions of the connected devices
when playing them.
Selecting the input source
Press the input source select button
(BD, SAT/CBL, TV, NET/USB, DVD,
V.AUX, DOCK, TUNER, GAME1,
GAME2 or CD) to be played back.
The desired input source can be selected
directly.
You can also use the following operation to select an input
source.
nUsing the button on the main unit
Press the input source select button (TUNER, BD, SAT/CBL, TV,
GAME1/2, DVD, DOCK, CD, V.AUX, NET/USB) to be played back.
•When iPod 1 on the main unit is pressed, the input source
of this unit is switched to “DOCK” or “NET/USB” and the
connected iPod is automatically played (vm page 25 “iPod
play function”).
nUsing the “Source Select” menu
Switch the remote control unit to the J (MAIN ZONE) mode
when performing this operation (vm page 102 “Operating AV
device”).
If the remote control unit is in K (ZONE2) mode, the “Source
Select” menu will not be displayed when SOURCE SELECT is
pressed.
Player
BD
DVD
CD
DOCK
USB/iPod
Video
SAT/CBL
TV
GAME1
GAME2
V.AUX
Tuner
TUNER
Network
Favorites
Internet Radio
Media Server
Flickr
Last.fm
Napster
[ENTER] Enter[ ] Move
Source Select
The currently selected input
source is highlighted.
q Press SOURCE SELECT.
Display the “Source Select” menu.
w Use uio p to select the input source,
then press ENTER.
The input source is set and the source
selection menu is turned off.
•When using with an iPod connected directly to the USB port of this
unit, select “USB/iPod” for the input source.
•Input sources that are not going to be used can be set ahead of time.
Make this setting at “Source Delete” (vm page 92).
•To turn off the source selection menu without selecting an input
source, press SOURCE SELECT again.
•When SOURCE SELECT is pressed, the AMP-operation mode starts
automatically (vm page 102).
Selecting the input source
To Next Page
Loading...
