EasyManuals Logo

Denon AVR-1912 Getting Started

Denon AVR-1912
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
3
Setup Wizard Playback
ENGliShDEutSchFrANçAiSitAliANoESpAñolNEDErlANDSSVENSKA
РУССКИЙPOLSKITÜRKÇE
Preparation
Connect this unit to the television using an HDMI cable
(sold separately)
NOTE
If this unit is connected using cables other than the HDMI cable, the Setup Wizard
will not be displayed.
(ARC)
HDMI IN
2
Turn the television power on, and switch the video input to
this unit (HDMI input)
For details on how to operate the television, see the television instruction manual.
q Power on
w Switch the input to this unit (HDMI input)
3
Insert the provided batteries into the remote control unit
q Slide the rear lid in the direction of the arrow and remove it.
w Load the two batteries properly as indicated by the marks in the battery compartment.
R6/AA
e Put the rear cover back on.
4
vStart Setup Wizard on next page

Other manuals for Denon AVR-1912

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-1912 and is the answer not in the manual?

Denon AVR-1912 Specifications

General IconGeneral
Impedance47 Ω
Receiver typeSurround
Frequency range10 - 100000 Hz
Input sensitivity200 mV
Audio output channels7.1 channels
Audio A/D Converter (ADC)24-bit/96kHz
Signal-to-Noise Ratio (SNR)100 dB
Total Harmonic Distortion (THD)0.08 %
Power output per channel (1KHz@6 Ohm)125 W
Power output per channel (20-20KHz@8 Ohm)90 W
HDMI in6
Composite video in3
Component video (YPbPr/YCbCr) in1
Headphone connectivity6.3 mm
Connectivity technologyWired
Speakers connectivity typeBanana connector/Binding posts
Audio formats supportedAAC, FLAC, MP3, WAV, WMA
Image formats supportedJPG
Wi-FiNo
Ethernet LANYes
AM band range520 - 1710 kHz
FM band range87.5 - 107.9 MHz
Supported radio bandsAM, FM
Preset stations quantity56
Supported video modes1080i, 1080p, 480i, 480p, 576i, 576p, 720p
Analog signal format systemNTSC, PAL
Display-
Product colorBlack
Audio decodersDolby Digital EX, Dolby Digital Plus, Dolby Pro Logic II, Dolby Pro Logic IIx, Dolby Pro Logic IIz, Dolby TrueHD, DTS 96/24, DTS Neo:6, DTS-ES, DTS-ES (Discrete 6.1), DTS-ES (Matrix 6.1), DTS-HD
Apple docking compatibilityiPhone, iPod
AC input voltage120 V
AC input frequency60 Hz
Power consumption (standby)0.1 W
Power consumption (typical)460 W
Weight and Dimensions IconWeight and Dimensions
Depth382 mm
Width435 mm
Height167 mm
Weight10200 g

Related product manuals