16
ENGLISH
The surround mode used at last for the three types of input signals shown below is stored in the memory, and
the signal is automatically played with that surround mode the next time it is input.
Note that the surround mode setting is also stored separately for the different input sources.
q Analog and PCM 2-channel signals
w 2-channel signals of Dolby Digital, DTS or other multi-channel format
e Multi-channel signals of Dolby Digital, DTS or other multi-channel format
Setting the Auto Surround Mode
1
At the System Setup Menu select “Auto
Surround Mode” and press the ENTER button.
2
Select “ON” if you want to use the auto surround mode,
“OFF” if you do not want to use it.
3
Enter the setting.
The System Setup Menu reappears.
• Use this to turn the on-screen display (messages other than the menu screens) on or off.
Setting the on screen display (OSD)
1
At the System Setup Menu select “On Screen
Display” and press the ENTER button.
2
Select “ON” or “OFF”.
3
Enter the setting.
The System Setup Menu reappears.
• Sets the Trigger Out output for the different input sources.
Setting the Trigger Out Setup
1
At the System Setup Menu select “Trigger Out Setup”.
2
Switch to the Trigger Out Setup screen.
3
Select the input source and select “ON” or “OFF”.
4
Enter the setting.
The System Setup Menu reappears.
Use this to automatically search for FM broadcasts and store up to 40 stations at preset channels A1 to 8, B1 to
8, C1 to 8, D1 to 8 and E1 to 8.
NOTE:
• If an FM station cannot be preset automatically due to poor reception, use the “Manual tuning” operation to
tune in the station, then preset it using the manual “Preset memory” operation.
Auto tuner preset
1
At the System Setup Menu select “Auto Tuner Presets”.
2
Press the ENTER button.
The “Auto Preset Memory” screen appears.
To Next Page
Loading...
Need help?
General
