._ Fer instructions on operations using the MULTI ZONE FUNCTIONS. (See page 65 - 67)
[1] ZONE 2 preout CONNECTIONS
• If anether power amplifier er pre-main (integrated) amplifier or is connected, the ZONE2 preout (variable/fixed level) jacks carl be used te play a
different pregram seurce in ZONE2 the same time. (See page 67)
• The ZONE2 video out is only for the ZONE2.
RC-616
ZONE2 INFRARED
[ Integratedpro-main amplfier RC-6171NFRARED ] _lRi TRANSMITTER
)lifter SENSOR OUTPUT INPUT DE_4ON
_ "_'ON [] ............................................................
° °© J ....................................... uxouT
°o o o o© ......... []
I
I I
Extension jacks for future use.
-- CONTROL terminal
Performthe following ope@tion before using an external conloller connected to the R8--232C terminak
1. Press the ON/STANDBYbutton on the main unit and set the unit to the operating mode•
2. Perform the operation to turn off the power from the external control•
3. Check that the product has been set to the standby mode•
After checking the above,check the connections of the external controller• Operation is possible•
[2] ZONE2 SPEAKER OUT and PREOUT CONNECTIONS
• If another pewer amplifier or pre-main (integrated) amplifier is cennected, the ZONE2 eutput terminals can be used to play a different pregram
source in ZONE2 the same time.
• ZONE2 SPEAKER OUT can be used when "ZONE2" is selected at System Setup Menu "Power Amp Assign". In this case, Surreund Back
Speaker OUT cannet be used for MAIN ZONE. (See page 43)
'D
,B
,D
,B
I
RC-616
Integrated pre-ma[naZOl_[Ee2rRC-617INFRARED 1 'NF#pAREDM'TTER
or power amplf[er SENSOR
o --PUT...................................................................................II UXOUT
_[] [] o ........................
° o ...... , Io _.........1
[] / []
i
©@@@=
©@=@@'_ , !_ = I =° i
4 _-,_-,_Extensionjacks for future use
NOTE: _
• Thesettingsmust + - + -
this speaker for
ZONE2.
(See page 43•)
I SURROUND BACK/ZONE2 SPEAKERSYSTEMS ]
11
To Next Page
Loading...
Need help?
General
