19
AVR-3310CI/AVR-3310/AVR990/AVC-3310
2.3. Clearing the protection history
There are two ways to clear the protection history, as described below.
(1) Start up the error (protection history display) mode, display the error, then press and hold in the "ENTER" button for 3
seconds.
Press and hold in the "ENTER" button for 3 seconds
The above is displayed and the protection history is cleared.
(2) Initialize.
※ If you want to save a backup, use the method in 2.3.(1) above.
Warning indication by the STANDBY LED
If the power is turned off when a protection incident has been detected, the STANDBY LED (red) flashes as follows as
warning according to the conditions in which the protection incident occurred.
(1) ASO/DC PROTECTION : Flashes in cycles of 0.5 seconds (0.25 seconds lit, 0.25 seconds off)
(2) THERMAL PROTECTION : Flashes in cycles of 2 seconds (1 second lit, 1 second off)
3. Mode for switching tuner frequency step ---E2 model only--- f
P
ROTEC T H I S TORY
:
THERMAL
P
ROTEC T H I S TORY
:
NO PROTECT
3.1. Operation specification
Change tuner frequency step to FM:200kHz/AM:10kHz STEP.
Starting up:
1.With the "STANDARD" and "DIRECT/STEREO" buttons pressed, press the "ON/OFF"
button to turn the power on.
䇭"*Tuner FRQ Set"䇭appears on the display.
*Tuner FRQ Set
䂳
AM9 / FM5 0
䂩
2.Use
䂴䂪 and select "<AM10/FM200>".
*Tuner FRQ Set
䂳
AM1 0 / FM2 0 0
䂩
3.Press the "ENTER" button.
4. Press the "ON/OFF" button to turn the power off.
5. Then, press the "ON/OFF" button to turn the power on.
NOT
: Backup data(Remove settings for Installer Setup) initialization is carried out automatically.
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
Need help?
General
