115
Subwoofer Level
Default settings are underlined.
Sets the subwoofer on/off and its output level.
Setting items Setting details
Subwoofer
Turn subwoofer output on
and off.
On : The subwoofer is used.
Off : The subwoofer is not used.
NOTE
This can be set when the sound mode is “DIRECT” and “PURE
DIRECT” (vpage 75) and the “Subwoofer Mode” (vpage 131) is
“LFE+Main”.
Subwoofer Level
Set the subwoofer output
level.
–12.0dB – +12.0dB (0dB)
Restorer
Compressed audio formats such as MP3, WMA (Windows Media Audio) and MPEG-4 AAC reduce the
amount of data by eliminating signal components that are hard for the human ear to hear. The “Restorer”
function generates the signals eliminated upon compression, restoring the sound to conditions near those
of the original sound before compression. It also corrects the sense of volume of the bass to obtain richer
sound with compressed audio signals.
Setting items Setting details
Mode
Set the mode for
“Restorer”.
Off : Do not use “Restorer”.
Mode 1 (High) : Optimized mode for compressed sources with very weak
highs (64 kbps and under).
Mode 2 (Middle) : Apply suitable bass and treble boost for all compressed
sources (96 kbps and under).
Mode 3 (Low) : Optimized mode for compressed sources with normal
highs (96 kbps and over).
•This item can be set with analog signals or PCM signal (Sample Rate =
44.1/48 kHz) is input.
•“Restorer” settings are stored for each input source.
•This item default setting for “NETWORK” and “iPod/USB” is “Mode 3
(Low)”. All others are set to “Off”.
•This cannot be set when the sound mode is set to “DIRECT” or “PURE
DIRECT”.
Audio
Tone
Default settings are underlined.
Adjust the tonal quality of the sound.
Setting items Setting details
Tone Control
Set the tone control function
to “On” and “Off”.
On : Allow tone adjustment (bass, treble).
Off : Playback without tone adjustment.
“Tone Control” can be set when “Dynamic EQ” (vpage117) is set
to “Off”.
NOTE
•“Tone Control” settings are not reflected to ZONE2 and ZONE3.
•The tone cannot be adjusted in the “DIRECT” and “PURE DIRECT”
mode.
Bass
Adjust bass.
–6dB – +6dB (0dB)
“Bass” can be set when the menu “Tone Control” setting is “On”.
Treble
Adjust treble.
–6dB – +6dB (0dB)
“Treble” can be set when the menu “Tone Control” setting is “On”.
Dialogue Level
Default settings are underlined.
Sets the output level to clarify the dialogue output from the center channel.
Setting items Setting details
Dialogue
–12.0dB – +12.0dB (0dB)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
