123
Video
Volume Display
Default settings are underlined.
Sets where to display the master volume level.
Setting items Setting details
Volume
Bottom : Display at the bottom.
Top : Display at the top.
Off : Turn display off.
When the master volume display is hard to see when superimposed
on movie subtitles, set to “Top”.
Info Display
Default settings are underlined.
Displays status of operation temporarily when the sound mode is changed, or input source is switched.
You can set whether or not to show each of these status displays.
Setting items Setting details
On-screen Info
On : Turn display on.
Off : Turn display off.
Audio Display
Default settings are underlined.
Sets how long each menu is displayed when the input source is “NETWORK”, “iPod/USB”, or
“HDRadio”.
Setting items Setting details
Audio
Always : Show display continuously.
30s : Show display for 30 seconds after operation.
10s : Show display for 10 seconds after operation.
Off : Turn display off.
TV Format
Default settings are underlined.
Set the video signal format to be output for the TV you are using.
Setting items Setting details
Format
NTSC : Select NTSC output.
PAL : Select PAL output.
“Format” can also be set by the following procedure. However, the menu
screen is not displayed.
1. Press and hold the main unit’s o p for at least 3 seconds.
“V.Format : <NTSC>” appears on the display.
2. Use the main unit’s o p and set the video signal format.
3. Press the main unit’s ENTER to complete the setting.
NOTE
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
