Denon AVR-982

• if your AV component is not a DENON product or it cannot be operated with the preset memory codesets, you can "teach" the AVR-2802/982'S
remote control to "learn" the codes from the component's original remote control.
• The buttons that can be "learned" are the CD, TAPE and CDR/MD system buttons (see page 28) and
the DVD, VDP, VCR and TV system buttons {see page 31). (For the CD, CDR/MD, DVD, VDP and TV, the
A block buttons can also be "learned", and for the DVD and TV, the B block buttons can also be
"learned".)
1
Press the USE/LEARN selector button with the tip of a pen
etc., to set the learn mode. Both the START and LEARNED/TX
indicators flash. Hashes
This unit's remote
control unit
2
Set the program switch to the side to be learned.
Set to the AUDIO side for the CD, tape deck or CDR/MD
position, to the VIDEO side for the DVD, VDP, VCR or TV
position.
AUDIO
_ v'_Ng
Set the program switch to the position to be learned.
T_E CD_MD
cD __MULTI
_TT_
VDP VCR
set the remote control units so they are facing each other,
then press the button to be learned on this unit's remote
control unit.
Transmitting windows Othelremote
Light,\\\\
c°ntr°l unit
The indicator stops flashing and the START LED lights.
The learnable buttons are the buttons which can be operated
with the DENON system codes for the CD player, tape deck,
CD recorder, MD recorder, the buttons which can be operated
with the preset memory for the DVD, VCR, VDP and TV. For
the TV only, however, the buttons in the section indicated "A"
on the diagram above can also be "learned". Use these to
"learn" TV channels.
Check that the START LED is lit, then press the button to be
"learned" on the other remote control unit.
Once the START LED turns off and the LEARNEDfrX LED
lights, release the button on the other remote control unit.
The two LEDs start
flashing again Light
To "learn" other buttons, repeat steps 2 to 6.
8
Once the learning operation is completed, press the
USE/LEARN selector button again.
The two LEDs stop flashing and the learning mode is
cancelled. _ twha_ktheoptOrrl_!
NOTES:
• Up to 26 codes can be "learned", but this number may be lower if the codes are long.
• If a nonqearnable button is pressed or two or more buttons are pressed at once, the two LEDs will once again light when the button{s)
is released.
• If the codes could not be stored, the LEARNEDfrX LED does not light after the START LED turns off. For limited number of models, codes
cannot be stored in RC-903.
• If the two LEDs start flashing rapidly after the START LED lights, this means that the memory is already full, and the code you have just
attempted to store was not stored.
To "learn" that code, first perform the resetting operation. {See page 35.)
32