1
4
®os
( }
2
3
1,5 _o o o
Press the USE/LEARN selector button with the tip of a pen,
etc., to set the learn mode.
4
To clear "learned" remote control signals, set the slide switch
to the position at which the signals were "learned".
AUDIO
Set the slide switch to the position at which the signals were
"learned".
T_E CD_MD
D_Y'TT_
VDP VCR
Press the SYSTEM CALL SET button, and hold it in for at least
four seconds.
• When both the START and LEARNEDfrX LEDs light
simultaneously, all the stored codes are cleared.
@h
Press the USE/LEARN selector button.
[] OPERATION
Refer to "CONNECTIONS" (pages 6 to 13) and check that all
connections are correct.
Set the remote control unit's slide AUO_O
SWitCh tO the AUDIO position. (only
when operating with the remote
control unit)
Turn on the power.
Press the POWER switch (button).
oN JSTANDBy
ON/STANDBY
(Mainurlit) (Remotecontrolunit)
When pressed, the power turns on and the display lights. The sound
is muted for several seconds, after which the unit operates normally.
When pressed again, the power turns off, the standby mode is set
and the display turns off.
Whenever the ON/STANDBY button is in the STANDBY state, the
apparatus is still connected on AC line voltage. Please be sure to
unplug the cord when you leave home for, say, a vacation.
4
Select the front speakers.
Press SPEAKER A or B turn the speaker on.
SPEAKER
O O
A m SPEAKER
@@0_
4 _ _ 5 _
2
To Next Page
Loading...
Need help?
General
