Denon AVR-982

[] CONNECTIONS
• DO not plug in the AC cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left with
left, right with right).
• Insert the plugs securely. Incomplete connections will result in the
generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.
• Note that binding pin plug cords together with AC cords or placing
them near a power transformer will result in generating hum or
other noise.
• Noise or humming may be generated if a connected audio
equipment is used independently without turning the power of this
unit on. If this happens, turn on the power of the this unit.
• When making connections, also refer to the operating instructions of the other components.
The power to these outlets is turned on and off when the power is switched between on and standby from the remote control unit or power
switch.
OU_I_OT CD player
I Connecting a turntable ]
Cor_[_ect the tumtable's output cord to the AVR
2802/982rs PHONO iacks, the L {Feft) PlU9 to the L
jack,, the R (right) plug to the ri9ht jack
Tumtable
(MM cartridge)
Ground _
wl_e
{Connecting the AC OUTLETS ]
AC OUTLETS
• SWITCHED
(total capacity /20 W (1 A ))
The power to these Outlets is turned on and off in coniunct_on w_th the
POWER operation switch on the main unit, and when the power is switched
between on and standby from the remote control unit
driers, TVs ot other electrical appliances
I Connecting the pro*out jacks I
Use these iacks if you wish to conllect externaJ power amplifier(s) to
increase the power of the front, ceiitet, surlound alld suiround back
soured chanr_els, or for co_nectiorl to powered Ioudspeakels
To use Surround bac_, with one speaker, connect the exterila_ power
ampiifler to SURR BACK L CH
S
_n_r,_
MD recotder, CD recorde[ or other component
equipped with digital input/output iacks
i O _ CD player or other
_ _ DDDD component equlpped
o o _ o _ _ with digital output jacks R L R L
OUTPUT _NPt;T OUTI_U
i Connecting the DIGITAL jacks ]
Use these for collnect_ons to audio (v_deol equipment with digital output Refer to page 24
for instructions on settling this terminal
AC /20 V, 60 Hz
CD recorder or Tape deck,
= _ a _acn NOTE:
, _ _ • away
Connecting a tape deck]
Connections for recording:
Connect tile tape deck's recording _rlpu_ iac_,s (LINE _N or REC) to this urllt's tape
recording {CDR/TAPE OUT) jacks using pin plug cords
Connections for playback:
Corl[lect the tape deck's playback output jacks {LINE OUT or PB) to this urllt's tape
playback, (CDR/TAPE IN) jacks using pirl plug cords
6