ZONE2 Setup
Makes settings for audio playback with ZONE2.
0
Values set for “Volume Limit” and “Power On Volume” are displayed according to
the setting specified for the volume “Scale”. (v p. 160)
0
This can be set when “Amp Assign” is set to “5.1ch + ZONE2”. (v p. 188)
o
Volume Level
Set the volume output level.
Variable
(Default):
Volume can be adjusted.
1 – 98
(–79 dB – 18 dB):
Volume is fixed at the desired level. The
volume cannot be adjusting using the
remote control unit.
0
The dB value is displayed when the “Scale” setting is “ –79.5 dB – 18.0 dB”.
(v p. 160)
o
Volume Limit
Make a setting for maximum volume.
60 – 80 (–20 dB – 0 dB)
(Default : 70 (-10 dB))
Off: Do not set a maximum volume.
0
This can be set when “Volume Level” is set to “Variable”. (v p. 210)
0
The dB value is displayed when the “Scale” setting is “-79.5 dB - 18.0 dB”.
(v p. 160)
Contents Connections Playback Settings Tips Appendix
210
Front panel Display Rear panel Remote Index
To Next Page
Loading...
