Listening to FM/AM broadcasts
1
Connect the antenna. (“Connecting FM/AM
antennas” (v p. 57))
2
Press TUNER to switch the input source to “Tuner”.
G TV screen H
OPTION
STEREO AUTO
CH 1
FM 87.50 MHz
Tuner
Tune Preset
Option
Now Playing
01 FM 87.50MHz
GDisplay of this unitH
3
Press OPTION.
The option menu screen is displayed.
4
Use cursor Up/Down to select “FM/AM”, then press
ENTER.
This displays the reception band input screen.
5
Use cursor Left/Right to select “FM” or “AM”, then
press ENTER.
FM: When listening to an FM broadcast.
AM: When listening to an AM broadcast.
6
Press TUNE + or TUNE – to select the station you want
listen to.
Scanning is performed until it finds an available radio station. When
it finds a radio station, it stops the scan automatically and tunes in.
0
The modes for receiving FM broadcasts consists of “Auto” mode that automatically
searches available broadcast stations and “Manual” mode that lets you tune in
using buttons to change the frequency. The default setting is “Auto”. You can also
use “Direct Tune” to tune in by entering the frequency directly.
In “Auto” mode, you cannot tune in to radio stations if the reception is not good.
If this is the case, then use the “Manual” mode or “Direct Tune” mode to tune in.
0
You can also switch the reception band by pressing BAND on the unit.
0
You can also scan the broadcast station by pressing TUNE + or TUNE – on the
unit.
Operation buttons Function
TUNE +, – Selects the radio station (up/down)
CH/PAGE d f
Selects preset radio stations
Cursor Up/Down Selects the radio station (up/down)
Cursor Left/Right Selects preset radio stations
Contents Connections Playback Settings Tips Appendix
78
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
