Denon AVR-S770H User Manual

Manual Setup
Perform when setting the speakers manually or when changing settings
made in Audyssey
®
Setup.
0
If you enable new speakers in the Speaker Layout menu after
performing Audyssey
®
Setup, you will no longer be able to select
Audyssey MultEQ
®
, Audyssey Dynamic EQ
®
or Audyssey Dynamic
Volume
®
. (v p. 161)
0
Changing the following settings:
Distances / Levels / Crossovers settings will not disable Audyssey
®
or
require running Audyssey
®
Setup again.
0
“Manual Setup” can be used without changing the settings. Please set if
necessary.
Speaker Layout
Select a suitable speaker layout for your speaker system.
o
Amp Assign
Select the power amplifier usage method to match your speaker
system.
You need to configure the detailed settings for the speaker
configuration in accordance with the selected mode. Select Amp
Assign configure the corresponding detailed settings.
7.1ch
(Default):
Settings to assign all power amplifier within
this unit to MAIN ZONE to play back up to
7.1-channels.
5.1ch + ZONE2:
Setting to assign the unit’s built-in power
amplifier for ZONE2 and output the audio in
stereo.
Contents Connections Playback Settings Tips Appendix
188
Front panel Display Rear panel Remote Index

Denon AVR-S770H Specifications

General

Channels	7.2
HDMI Inputs	6
Dolby Atmos	Yes
DTS:X	Yes
Wi-Fi	Yes
Bluetooth	Yes
HEOS Built-in	Yes
Voice Control	Amazon Alexa, Google Assistant, Apple Siri
4K/120Hz Pass-through	Yes
8K/60Hz Pass-through	Yes
Total Harmonic Distortion	0.08% (20Hz-20kHz)
Input Sensitivity/Impedance	200mV/47k ohms
Signal-to-Noise Ratio	98 dB (IHF-A weighted, Direct mode)
Ethernet Port	Yes
HDR Support	HDR10+, Dolby Vision, HLG
Frequency Response	10Hz-100kHz
USB Port	Yes
HDMI Outputs	1