Audyssey MultEQ
®
, Audyssey Dynamic EQ
®
and Audyssey Dynamic Volume
®
cannot be selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup. (v p. 178)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. (v p. 118)
0
These cannot be selected when sound mode is “DTS Virtual:X” or sound mode that have “+Virtual:X” in the sound mode name.
0
These cannot be selected when using the headphones.
“Restorer” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
surround, “Restorer” cannot be used. (v p. 159)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. (v p. 118)
No sound is output when using ZONE2.
0
The analog audio signal and the 2-channel PCM signal input from digital connectors (OPTICAL) can be played back in ZONE2.
0
When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a
range of about 30 m.
Sound mode settings are not available when using Bluetooth headphones. Audio menu settings are also not available.
0
This unit cannot change sound mode or audio menu settings for audio output to Bluetooth headphones.
Contents Connections Playback Settings Tips Appendix
229
Front panel Display Rear panel Remote Index
To Next Page
Loading...
