Bass
Set subwoofer and LFE signal range playback.
o
Subwoofer Output
Selects which low frequency signals are sent to the subwoofer outputs.
LFE
(Default):
The subwoofer outputs receive the LFE
track, plus any redirected bass from
speakers with crossovers set. Use this
setting as the default for home theater
bass management in a typical room.
LFE + Main:
The subwoofer outputs receive the LFE
track, plus redirected bass, and a copy of
the low frequency signals from all large
speakers.
0
“Subwoofer Output” can be set when “Speaker Configuration” - “Subwoofer” in
the menu is set to “Yes”. (v p. 188)
0
Play music or a movie source and select the mode offering the strongest bass.
0
If “Speaker Configuration” - “Front” and “Center” are set to “Large”, and
“Subwoofer Output” is set to “LFE”, no sound may be output from the
subwoofers, depending on the input signal or selected sound mode.
(v p. 188)
Select “LFE + Main” if you want the bass signals to always be produced from
the subwoofer.
o
LPF for LFE
Selects the crossover point for the LFE channel. Set this when you
want to change the playback LFE signal of the subwoofer.
80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz /
200 Hz / 250 Hz (Default: 120 Hz)
Contents Connections Playback Settings Tips Appendix
195
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
