EasyManuals Logo

Denon AVR-S970H User Manual

Denon AVR-S970H
283 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #260 background imageLoading...
Page #260 background image
z1
During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z2
This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD or Dolby Atmos signal is played.
z3
This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS:X, DTS-HD or DTS signal is played.
z4
This item can be selected when a DTS:X signal that is compatible with the Dialog Control function is input.
z5
This can be set when the LFE signal is included in the input signal.
z6
This item can be set when any Height, Ceiling or Dolby Atmos Enabled speakers are not used, or Surround speakers are not used.
z7 This item cannot be set when “Dynamic EQ” is set to “On”. (v p. 159)
z8 This item cannot be set when “Speaker Configuration” - “Subwoofer” in the menu is set to “No”. (v p. 188)
z9
This item cannot be set when Audyssey
®
Setup (Speaker Calibration) has not been performed.
z10
This item cannot be selected when a DTS:X format with a sampling frequency of over 48 kHz is input.
z11
This item cannot be set when sound mode is “DTS Virtual:X” or sound mode that have “+Virtual:X” in the sound mode name.
z12
This item cannot be set when “MultEQ
®
” in the menu is set to “Off”. (v p. 158)
z13
This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
z14 This setting is available when “Bass” - “Subwoofer Output” in the menu is set to “LFE + Main”. (v p. 195)
z15 This item can be set when “Speaker Configuration” - “Front” is set to “Small” or “Bass” - “Subwoofer Output” is set to “LFE + Main”. (v p. 188, 195)
Contents
Connections Playback Settings Tips Appendix
260
Front panel Display Rear panel Remote Index

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-S970H and is the answer not in the manual?

Denon AVR-S970H Specifications

General IconGeneral
Receiver type-
Pre-out channels0.2
Pre-out connectivityYes
Audio output channels7.1 channels
Power output per channel (1KHz@6 Ohm)125 W
Power output per channel (20-20KHz@8 Ohm)85 W
HDMI in6
Audio (L/R) in4
USB ports quantity1
Digital audio coaxial in0
Digital audio optical in2
Audio (L/R) out7
Audio formats supportedAAC, ALAC, FLAC, MP3, WAV, WMA
Supported radio bandsAM, FM
Optical drive includedNo
DisplayVFD
HDCP version2.3
Product colorBlack
Audio decodersDTS Virtual:X, DTS-HD Master Audio, DTS:X, Dolby Atmos, Dolby Surround, Dolby TrueHD
Volume controlRotary
Number of products included1 pc(s)
Power consumption (standby)0.1 W
Power consumption (typical)500 W
Package weight11500 g
Weight and Dimensions IconWeight and Dimensions
Depth341 mm
Width434 mm
Height167 mm
Weight9500 g

Related product manuals