1.8. The rmware update nishes.
When the update is completed, the following message appears on the display, then the unit returns to the normal status.
Display
FLD
U p d a t i n g C o m p l e t e
---Cautions on Firmware Update---
• Never remove the USB memory before the update is nished.
• Never turn off the power before the update is completed.
• It takes around 1 hour to complete the update.
Once an update is started, normal operations cannot be performed until it is completed.
The GUI menu settings and image adjustment settings of this unit may be initialized.
Note down the settings before updating, and set them again after updating.
1.9. Forced USB All Device Write Mode
1.9.1. Actions
Mode used when this unit cannot be recovered.
Forcibly switches this unit to USB update mode.
1.9.2. Operations
While holding down buttons the "
TUNER PRESET CH -
" and "
STATUS
" buttons simultaneously, insert the AC plug to
turn the power on.
1.9.3. The rmware update nishes.
Returns to the normal status after update is completed.
1.10. Update Procedure in the Event of a CY920 Error
1.10.1. Actions
Perform the following update procedure if "
CY920 Error
" appears in the display when the power is turned on after re-
placing the DIGITAL PCB or the CY920.
1.10.2. Operations
(1) Remove the AC power plug and turn off the power.
(2) Copy the update le to a USB memory device and insert the USB memory device in the USB port.
(3) Insert the AC plug and turn on the power.
(4) The update starts automatically after "
CY920 Error
" appears in the display.
Display
FLD
U p d a t e F i l e C h e c k
(5) The rmware update nishes.
Display
FLD
U p d a t e C o m p l e t e
The unit restarts after the update is nished.
(6) After the update, check that "CY920 Error" is no longer displayed, and check the version of the new rmware.
See "1. Version Display Mode" (page 19 ).
70
To Next Page
Loading...
Need help?
General
Weight and Dimensions
