Check the USB device being used
Is the USB device supported by this unit?
Is a USB hub being used?
This unit supports devices in the FAT16- and
FAT32-formatted mass storage class, MTP-com-
patible devices (except for some models).
Do not use a USB hub.
Checking the unit
Can a voltage (5V) be conrmed between [JK608 :
1 - 4pin] (USB Connector) on FRONT PCB?
The USB signal circuit between Network Module and [JK608] of the FRONT PCB are faulty.
Are [CN321] of the DIGITAL PCB and [BN321] of
the FRONT PCB correctly connected?
The circuit around [IC503] of the DIGITAL PCB is
faulty.
Connect the connectors correctly.
5.3. Cannot recognize the connected USB device
Checking the unit (If no picture is output)
• Check the VIDEO circuit.
Are digital video signals(LEGOPCK, LEGOVS,
LEGOHS, LEGODE, LEGOVD0-LEGOVD23) output
from Network Module to [IC421 : V.PLD]?
Checking the unit:(If no sound is output)
Check the [IC251 : DSP1] AUDIO circuit and the circuits thereafter.
Are the I2S signal output to [CN501 : 7, 11, 13,
14pin] of the DIGITAL PCB ?
Are audio signal output to Test point D1I_F/FL on
DIGITAL PCB.
5.4. No picture or sound is output
The circuit around Network Module, [IC421 : V.PLD]
is faulty.
Network Module is faulty.
The circuit around [IC221 : A.PLD] is faulty.
NO
NO
NO
YES
YES
YES
NO
YES
YES
YES
YES
NO
NO
NO
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
98
To Next Page
Loading...
Need help?
General
Weight and Dimensions
