Denon DN-700C

30
Getting started
Part names
and functions
Connections Control functionSetting Defaults
File and folder
settings
Playback Information
Required system
n Ethernet cable (CAT-5 or greater recommended)
•Use only a shielded STP or ScTP LAN cable which is available at retailer.
•The normal shielded-type Ethernet cable is recommended. If a flat-type cable or unshielded-type cable
is used, other devices could be affected by noise.
•When using this unit connected to a network with no DHCP function, make the settings for the IP
address, etc., at “System Setting” (vpage18).
•When setting manually, check the setting contents with the network administrator.
NOTE
DENON assumes no responsibility whatsoever for any communication errors or troubles resulting from
customer’s network environment or connected devices.
You can connect this unit to your network (LAN) to perform various types of playbacks and operations as
follows. Make network connections for this unit by carefully reading information on this page.
•Streaming playback of tracks from a media server on the network
•Control of the DN-700C via the network
Network settings need to be configured after the network (LAN) is connected. For details, see “Network
Settings” (vpage31).
Internet
To WAN
Router
To LAN side port
To LAN side port
LAN port/
Ethernet
terminal
LAN port/Ethernet
terminal
Computer
Media server, NAS
(Network Attached Storage)
Modem
Connecting to a network (LAN)