15
DN-HD2500
5
PANEL CHK
mode
Turn the Deck1 or Deck2 PARAMETERS knob
to select "PANEL CHK" from the service
mode's top menu, then press the PARAME-
TERS knob to set "PANEL CHK" mode, and
then the "PANEL CHK" mode screen appears.
Checks (1) to (6) are performed.
1) FADERIN signal
When the cue or play signal is received on
the FADER1 and FADER2 terminal, the
"FADERIN CUE" or "FADERIN PLAY" check-
box on the screen is highlighted for 0.5 sec-
onds.
2) PARAMETERS knob
The checkbox display toggles between black
and white each time the PARAMETERS
knob is pressed.
When the PARAMETERS knob is turned, ->
(clockwise) or <- (counterclockwise) is dis-
played.
3) JOG disc
When the unit detects that the JOG disc has
been touched, the checkbox is highlighted
and the position of detection ("Right",
"Down", "Left" or "Up") is displayed in the [ ]
section.
When the JOG disc is turned, -> (clockwise)
or <- (counterclockwise) is displayed.
The counter value of the turning pulse num-
ber of the JOG disc is indicated on the
"COUNT" section within the range of 0 to
65535, counting up when turned clockwise,
down when turned counterclockwise.
The count value for back spin checking is
indicated on the "COUNT" section. "0" is
displayed if you touch the JOG disc, "move"
if you turn it, and the number of rotations if
you stop it. If values of three rotations and
greater are displayed, things are normal.
The counter value of the turning pulse width
of the JOG disc is indicated on the
"WIDTH" section within the range of 0 to
65535, decreasing when turned quickly,
increasing when turned slowly.
When the pulse width is set, the pulse width
setting flag checkbox ("WD") is highlighted.
The counter value of the turning pulse
width of the JOG disc and pulse width set-
ting flag are for design examination. For
this reason, do not use them as judging
criteria for the jog dial; handle them as ref-
erence data.
4) PITCH slider
The pitch slider's position reading value is
displayed on the "PITCH" section, the center
tap's position reading value at the "CENTER"
section, both within a range of 0 to 1022.
Fader value :
MAX 1018 or more
Click point Center Tap value 25
MIN 6 or less
Center Tap value
MAX 435 589
No Mode Operation and Function Display
2
2
Display when not in the touch count operation mode
("PANEL CHK" mode initial screen)
JOG ディスクの回転パルス幅のカウンタ値及
びパルス幅確定フラグは、設計検討用のため
ＪOG ダイヤルの判定基準に使用せず、参考
データとして扱ってください。
No モード 操 作 と 機 能 表 示
2
2
To Next Page
Loading...
