20
2.2. Cannot connect to network
Is First Setup correct?
Check the Power Supply Voltages for DAC.
MAIN B'D
• +5V_A, [IC103] : 11pin
Set First Setup properly.
Set the IP address and other parameters properly. For a xed
IP setting, check whether the IP address is redundant with
that of other devices and the subnet mask setting is correct.
YES
NO
YES
Are the router's settings correct?
Are the router, hub and other peripherals properly connected?
Check the router's operating instructions and set it properly.
Check whether there are connection restrictions due to the
MAC address, etc.
Connect them properly to peripherals.
NO
NO
YES
μ
-com is initialized and set First Setup properly.
Refer to "CAUTIONS IN SERVICING" for the procedure of
initializing
μ
-com. (Refer to 6 page.)
To Next Page
Loading...
