8
[Precautions for Disassembly]
When disassembling, connect the F102 and GND with an ground lead, and discharge for approximately 10 seconds
before starting the disassembly.
1. FRONT PANEL ASSY
(1) Remove the screws.
(2) Cut the wire clamp band, then disconnect the connector wire and FFC cable. Remove the screws.
ground lead
GND
F102
TOP
COVER
FRONT PANEL ASSY
→
Proceeding :
View from the bottom
FFC cable
CP101
STYLE PIN : Loosen
cut
Please refer to "EXPLODED VIEW" for the disassembly method of each P.C.B included in FRONT PANEL ASSY.
To Next Page
Loading...
