Denon DNP-720AE - Connections; Connecting the Amplifier; Connecting to a Home Network (LAN); Basic Operations

7
DISASSEMBLY
• Disassemble in order of the arrow in the following gure.
• In the case of the re-assembling, assemble it in order of the reverse of the following ow.
• In the case of the re-assembling, observe "attention of assembling".
• If wire bundles are untied or moved to perform adjustment or replace parts etc., be sure to rearrange them neatly as
they were originally bundled or placed afterward.
Otherwise, incorrect arrangement can be a cause of noise generation.
About the photos used for "descriptions of the DISASSEMBLY" section
• The shooting direction of each photograph used herein is indicated on the left side of the respective photograph as
"Shooting direction: ***".
• Refer to the diagram below about the shooting direction of each photograph.
• Photographs with no shooting direction indicated were taken from the top of the set.
The viewpoint of each photograph
(Shooting direction)
［View from the top］
Front side
Shooting direction: B
Shooting direction: DShooting direction: C
Shooting direction: A
FRONT PANEL ASSY
Refer to "DISASSEMBLY
1. FRONT PANEL ASSY"
and "EXPLODED VIEW"
PCB FRONT
(Ref. No. of EXPLODED VIEW : 1-2)
PCB LED
(Ref. No. of EXPLODED VIEW : 2-1)
PCB KEY
(Ref. No. of EXPLODED VIEW : 2-2)
PCB USB
(Ref. No. of EXPLODED VIEW : 2-3)
SMPS PCB UNIT
Refer to "DISASSEMBLY
3. SMPS PCB UNIT"
and "EXPLODED VIEW"
SMPS PCB UNIT
(Ref. No. of EXPLODED VIEW : 3)
TUNER PACK
Refer to "DISASSEMBLY
4.TUNER PACK"
and "EXPLODED VIEW"
TUNER PACK
(Ref. No. of EXPLODED VIEW : 23)
WIFI MODULE
Refer to "DISASSEMBLY
5.WIFI MODULE"
and "EXPLODED VIEW"
WIFI MODULE
(Ref. No. of EXPLODED VIEW : 4)
TOP COVER
PCB MAIN
Refer to "DISASSEMBLY
2. PCB MAIN "
and "EXPLODED VIEW"
PCB MAIN
(Ref. No. of EXPLODED VIEW : 1-1)