Denon DRA-295 - Safety Precautions; Leakage Current Check; Specifications; Audio, Video, and Tuner Specifications

36
DRA-295
SPECIFICATIONS


 Audio Section
(Power Amplifier)
Rated output: 50W + 50W (8Ω/ohms, 20Hz ~ 20kHz with 0.08% T.H.D.)
Output terminals: A or B 4 to 16Ω/ohms
A + B 8 to 16Ω/ohms
(Analog)
LINE input - PRE OUT
Input sensitivity/input impedance: 200mV/47kΩ/kohms
Frequency response: 10Hz ~ 50kHz: ±1.5dB
S/N ratio: 98 dB (IHF-A weighted)
Total harmonic distortion: 0.009% (−3dB at rated output, 8Ω/ohms) (1kHz)
Rated output: 1.2V


 Video Section (U.S.A. & Canada model)
(Standard Video Jacks)
Input/output level and impedance: 1V p-p, 75Ω/ohms
Frequency response: 5Hz ~ 10MHz +1, −3dB


 Tuner Section
[FM] (note: µV at 75Ω/ohms, 0dBf = 1×10
-15
W) [AM]
Receiving range:
U.S.A. & Canada model 87.50MHz ~ 107.90MHz 520kHz ~ 1710kHz
Europe model 87.50MHz ~ 108.00MHz 522kHz ~ 1611kHz
Usable sensitivity: 1.4µV (14.2dBf) 18µV
50dB quieting sensitivity: MONO 2.8µV (20.2dBf)
STEREO 23µV (38.5dBf)
S/N ratio: MONO 80dB (IHF-A weighted)
STEREO 75dB (IHF-A weighted)
Total harmonic distortion: MONO 0.15% (1kHz)
STEREO 0.3% (1kHz)


 General
Power supply: AC120V, 60Hz (For U.S.A. & Canada model)
AC230V, 50Hz (For Europe model)
Power consumption: 3.0A (For U.S.A. & Canada model)
150W (For Europe model)
Maximum external dimensions: 434 (W) × 147 (H) × 417 (D) mm (17-3/32″ × 5-25/32″ × 16-27/64″)
Weight: 9.2kg (20lbs 4.5oz)


 Remote Control Unit
RC-895 (For U.S.A. & Canada model)
RC-907 (For Europe model)
Batteries: R06P/AA Type (two batteries)
External dimensions: 50 (W) × 179 (H) × 22 (D) mm (1-31/32″ × 7-3/64″ × 55/64″)
Weight: 125g (Approx. 7.5 oz) (including batteries)
* For purposes of improvement, specifications and design are subject to change without notice.
SAFETY PRECAUTIONS
The following check should be performed for the continued protection of the customer and service technician.
LEAKAGE CURRENT CHECK
Before returning the unit to the customer, make sure you make either (1) a leakage current check or (2) a line to chassis
resistance check. If the leakage current exceeds 0.5 milliamps, or if the resistance from chassis to either side of the
power cord is less than 460 kohms, the unit is defective.