Denon DRA-565RD - Troubleshooting and Specifications; Troubleshooting Common Issues; Technical Performance Specifications

SPEAKER CONNECTION
Confirm polarity (+, —) and left and right channels (L, R). Connect the
speaker pairs to the SPEAKER terminals A or B on the back panel.
Connections must be made with power cord disconnected.
Preparing the cord
1. Peel off the sheath.
ion Peel.
z_
2. Twist the wires.
Connecting the front speaker terminals
1. Loosen by turning counterclockwise.
2.
Notes on Connection
e Do not plug the power cord into the AC wall outlet until all
connections have been completed.
e@ Make sure channels are correctly connected. Connect Left
channels to Left channels and Right channels to Right
channels. Follow the color markings of plugs and terminals
to make sure mistakes are not made.
e Connect all pin-plugs securely, pushing them completly into
the jacks. Incomplete connections will cause noise genera-
tion.
¢ Binding the connection cables to power cords, or running
such cables close to power supply transformers will cause
humming or noise, and should thus be avoided.
Notes:
e Do not connect two FM antennas simultaneously.
e Even if an external AM antenna is used, do not disconnect
the AM loop antenna.
e Make sure AM loop antenna lead terminals do not touch
metal parts of the panel.
ENGLISH
CAUTION
Protective Circuit
This
set
is
equipped
with
a
high
speed
protective
circuit.
This
circuit
protects
the
internal
circuitry
from
damage
due
to
large
currents
flowing
when
the
speaker
jacks
are
not
completely
connected
or
when
an
output
is
generated
by
a
short circuit.
This
protective
circuit's
operation
cuts
off
the
output
to
the
speakers.
In
such
a
case,
be
sure
to
turn
the
power
to
the
set
off
and
check
the
connections
to
the
speakers.
Then
turn
the
power
on
again.
After
muting
for
several
seconds,
the
set
will
operate
normally.
11