Denon DRA-700AEDAB - Operation; Initial Setup and Basic Controls; Listening Modes and Audio Adjustments

11
ENGLISH
Operation
Playing the input source
Use FUNCTION to select the input source you want to
play.
Use VOLUME to adjust the volume.
• The volume level is displayed on the volume level display.
1
3
Start playback on the selected component.
For operating instructions, refer to the component’s manual.
2
About the button names in this explanation
<>
: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
[POWER ON]
VOLUME
[TUNER]
BAND
[MUTING]
STATUS
PRESET
FUNCTION
MENU
ENTER
[D H F G]
<POWER>
FUNCTION <SPEAKER> <TUNING> MENU
<LOUDNESS>
<SELECT>
BAND
<TONE DEFEAT>
<MODE> PRESET • ENTER
VOLUME
<ON/STANDBY>
<PHONES>
<CH VOL>
<DIMMER> STATUS
<TONE CONTROL><PURE DIRECT>
Before operating
Turning the sound off temporarily (MUTING)
Press [MUTING].
• Canceling MUTING mode:
To cancel the muting mode, either press [MUTING] or adjust the
volume.
Connect the headphones to
<
PHONES
>
.
• No sound is produced from the speakers automatically.
NOTE:
•To prevent hearing loss, be careful not to raise the volume level
excessively when using headphones.
Listening over headphones
Switching the speakers
Press
<
SPEAKER
>
to turn the corresponding speaker pair
on.
Press
<
ON/STANDBY
>
or [POWER ON].
• The power indicator blinks green and the power turns on.
Press
<
POWER
>
.
£ OFF:
The power turns off and the indicator is off.
¢ ON:
The power indicator lights red.
1
2
ENGLISH
Switching the brightness of the display
Press
<
DIMMER
>
.
The brightness of the display can be adjusted in three steps. The
display can also be turned off.
Checking the currently playing program source,
etc.
Press STATUS.
• The current program source and various settings are indicated on
the display.