What to do if my Denon Receiver powers off with a blinking power LED?
If your Denon Receiver powers off and the power LED is blinking, check the power supply voltages for the analog block and the digital block.
How to fix a Denon Receiver when the FLD doesn't light?
When the FLD (Fluorescent Display) doesn't light on your Denon Receiver, you should: * Check the fuse for any leaks or short-circuiting. * Check the power supply voltages for the system uCOM. * Check the reset signal for the system uCOM. * Check the oscillation waveform. * Check the power 50/60 signal. * Check the power supply voltages for the FLD. * Check the reset signal for the FLD. * Check the FLD drive signal for the FLD.
General| Input Sensitivity/Impedance | 200 mV / 47 k ohms |
|---|---|
| Frequency Response | 10 Hz - 100 kHz |
| FM Tuner Range | 87.5 - 108.0 MHz |
| AM Tuner Range | 522 - 1611 kHz |
| Inputs | Phono x 1 |
| Outputs | Headphone x 1 |
| AM Sensitivity | 30μV |
| Standby Power Consumption | 0.3 W |
To Next Page
