Denon DVD-5000 - Note for Parts List

aa ees OV.5000 mm
NOTE FOR PARTS LIST
@ Part indicated with the mark "©" are not always in stock and possibly to take a long period of time for supplying, or in
some case supplying of part may: be refused.
@ When ordering of part, clearly indicate "1" and "I" (i) to avoid mis-supplying.
@ Ordering part without stating its part number can not be supplied.
@ Part indicated with the mark "*" is not illustrated in the exploded view.
@ Not including Carbon Film +5%, 1/4W Type in the P.W.Board parts list. (Refer to the Schematic Diagram for those parts.)
WARNING:
Parts marked with this symbol A\Zzz have critical characteristics.
Use ONLY replacement parts recommended by the manufacturer.
@ Resistors
Ex: RN 14K 2E 182 G ER
Type Shape Power Resist- Allowable Others
and per- ance error
formance
: Carbon p : : Pulse-resistant type
: Composition : : : Low noise type
: Metal oxide film : : : Non-burning type
: Winding > i : Fuse-resistor
: Metal film : 3 : Lead wire forming
; Metal mixture
%* Resistance
é => 1800 ohm = 1.8 kohm
t Indicates number of zeros after effective number.
2-digit effective number.
¢ Units: ohm
3 => 1.20hm
1-digit effective number.
2-digit effective number, decimal point indicated by R.
* Units: ohm
@ Capacitors
Ex. CE O4W 4H 2R2 M BP
Type Shape Dielectric Capacity Allowable Others »
and per- strength error
formance
: Aluminum foil
electrotytic
: Aluminum solid
electrolytic
: Tantalum electrolytic
: Film
: Ceramic
: Ceramic
: Oi
: Mica
: Metallized
: Metallized
141% : High stability type
o on 1t2% : Non-polar type
1 £5% : Rippie-resistant type
7£10% : For change and discharge
1£20% : For assuring high
frequency
1480% :UL part
-20% : CSA part
: UL-CSA type
0% : Lead wire forming
7£0.25pF
:20.5pF
: Others
J
K
M
z
Pp:
c
D
=
%* Capacity (electrolyte only)
$ => 2200pF
indicates number of zeros after effective number.
2-digit effective number.
¢ Units: LF.
2B => 2.2uF
t eae 1-digit effective number.
2-digit effective number, decimal point indicated by R.
¢ Units: pF.
% Capacity (except electrolyte)
= 2200pF=0.0022yF
(More than 2)=-Indicates number of zeros after effective number.
@ Units: pF.
=> 220pF
(O or 1)
@ Units: pF.
« When the dielectric strength is indicated in AC, “AC” is included after the dieelectric
strength value.
2-digit effective number.
Indicates number of zeros after effective number.
2-digit effective number.
33