Explanatory Photos for DISASSEMBLY
• For the shooting direction of each photos used in this manual, see the photo below.
• A, B, C and D in the photo below indicate the shooting directions of photos.
• The photographs with no shooting direction indicated were taken from the top of the unit.
• Photos of HEOS AVR are used in this manual.
The viewpoint of each photograph
(Shooting direction : X) [View from the top]
Proceeding : REAR PANEL and TOP PANEL
(1)   Remove the screws.
(2)   Remove the catches on the bottom of the REAR PANEL.
(3)   Slide the top cover to the REAR side and remove the TOP COVER ASSY (TOP COVER + REAR PANEL).
 
Front side
Shooting
 direction: D
Shooting
 direction: C
↑Shooting direction: A↑
↓Shooting direction: B↓
1. REAR PANEL and TOP PANEL
x8
Proceeding : REAR PANEL and TOP PANEL → SIDE PANEL
(1)   Remove the screws.  Cut the wire clamps.
 
Proceeding : REAR PANEL and TOP PANEL → SIDE PANEL → FRONT PANEL ASSY
(1)   Remove the screws.  Remove the CORD HOLDER.  Cut the wire clamps.  
Remove the connector.
 
2. SIDE PANEL
↑Shooting direction: D↑ ↑Shooting direction: C↑
x4
CUTx7
3. FRONT PANEL ASSY
↑Shooting direction: D↑
↑Shooting direction: C↑
x2
x3x1
CN305
CUTx2
CORD HOLDERx3
41
Caution in 
servicing
Electrical Mechanical Repair Information Updating