Denon HEOS AVR - Digital Pcb; Bottom Cover

Proceeding : REAR PANEL and TOP PANEL → SIDE PANEL → FRONT PANEL ASSY
→ DIGITAL PCB
(1) Remove the screws.
(2) Remove the screws. Cut the wire clamps. Remove the connector.
(3) Cut the wire clamps. Remove the connector.
Make sure that the black PC SHEET does not catch on the HEAT SINK during assembly.
4. DIGITAL PCB
x3
x2
x1
x2
x2
CN31A
CN303
CN32A
CN502
CN305
CUTx7
LED COVER
GRAY
BLACK
CUTx2
Proceeding : REAR PANEL and TOP PANEL → SIDE PANEL → FRONT PANEL ASSY
→ DIGITAL PCB → BOTTOM COVER
(1) Remove the screws. Remove the REMOTE PCB.
(2) Remove the screws.
Proceeding : REAR PANEL and TOP PANEL → SIDE PANEL → FRONT PANEL ASSY
→ DIGITAL PCB → SMPS PCB
See "EXPLODED VIEW" for instructions on removing the SMPS PCB.
Proceeding : REAR PANEL and TOP PANEL → SIDE PANEL → FRONT PANEL ASSY
→ DIGITAL PCB → D-AMP PCB
See "EXPLODED VIEW" for instructions on removing the D-AMP PCB.
5. BOTTOM COVER
x8
REMOTE PCB
↑Shooting direction: D↑
↑Shooting direction: C↑
x4
x6
There is mounting direction
6. SMPS PCB
7. D-AMP PCB
42
Caution in
servicing
Electrical Mechanical Repair Information Updating