Operation mode select switchInput select switch
HIGH
--AUDIQ--
Bi-wiring connection
When using speakers that have input terminals for both woofer units
and
tweeter units, this connection
allows for the same signal
to
be output from
each
unit.
With this connection the interference between signals for the woofer unit and tweeter unit
is
low
so that
you
can
enjoy high quality sound
in
playback.
.~[.Ij.
The Operation
mode
select switch
and
Input select switch must
be
set before turning the power
on.
Settings which
are
changed after powering
on
will not be registered.
In
such cases, the
power
should be
switched off and
on
again.
'~[e$,.
When using Bi-Wiring connection use 4 -
16
OIohms speakers for the impedance.Operation
mode
select switch
Input select switch
e
Ej)
"@"
o
~
"@"
~D·-~
~
e
Ej)
Settings and Connections
Set
the rear panel "Operation
mode
select switch" and "Input select switch" according
to
the
connection method.
--AUDIO--
PRE PRE
~
;
SPEAKER B
II
SPEAKER A
Connection for signal input
to
each channel to be output from
the
channel's speaker terminal.
• Set
each
switch
as
shown below.
CD
Set
the Operation
mode
select switch to "'NORMAL"' (GT'page
6).
@
Set
the Input select switch according to the input (GT'page
6).
.
For
RCA
input Set to "'RCA"'.
.
For
XLR
input·······
Set
to "'XLR"'.
I·
Normal Connections·
Example: Normal connection to the 0 channel
*Setup
each channel
1111-
•.
0
-111)
using the same steps.
•
¢t,jj.
"The
same signal is output to speakers A
and
B.
• Please use the following speaker impedance.
. When using only speaker A or B ····························4 -
16
O/ohms
. When using speakers A and B at the same time ···8 -
16
O!ohms
9
To Next Page
Loading...
