AUTO STANDBY
When there is no input signal and operation for 15 minutes, this unit
automatically enters the standby mode.
ON (Default): The unit goes into standby after 15 minutes.
OFF:
The unit does not go into standby
automatically.
0
For the input source “ANALOG IN” only, when no operation is performed for eight
hours, this unit automatically enters the standby mode.
0
In the following situations, the Auto standby function does not operate.
0
When an iPod (From iPod) is connected to the USB port on the unit.
0
When the source is “TUNER”.
0
The default setting for the Auto Standby mode is “ON”.
CLOCK MODE
The clock is constantly displayed.
ON:
Display the clock.
Press the POWER X button to switch
between the clock display and the normal
display.
OFF
(Default):
Does not display the clock.
NOTE
0
When CLOCK MODE is set to ON, this unit consumes the same amount of power
as when it is turned on.
Contents Connections Playback Settings Tips Appendix
58
Front panel Display Rear panel
Remote
Index
To Next Page
Loading...
