Operation Section
1
–
16
7. INJECTOR (G2 TYPE)
7.1 Outline
z The injectors inject the high-pressure fuel from the rail into the combustion chambers at the optimum injection timing, rate, and spray
condition, in accordance with commands received from the ECU.
7.2 Characteristics
z A compact, energy-saving solenoid-control type TWV (Two-Way Valve) injector has been adopted.
z QR codes displaying various injector characteristics and the ID codes showing these in numeric form (30 alphanumeric figures) are
engraved on the injector head. The common rail system optimizes injection volume control using this information. When an injector
is newly installed in a vehicle, it is necessary to enter the ID codes in the engine ECU using the MITSUBISHI diagnosis tool (MUT
III).
To Next Page
Loading...