Denso BHT-904B - Page 125

111
Barcode Handy Terminal
3. d at the
y.
an error occurs, the tested slave BHT beeps three times and displays
s
.
( X X )
ta is different from the sent data.
2: A timeout has occurred during standby for data reception.
the Backspace/clear key to return to the TEST COMMUNICATION menu.
he master BHT automatically returns to the TEST COMMUNICATION menu 10 seconds after the
ccurren
pon no
isplays
ress th
enu.
he master BHT automatically returns to the TEST COMMUNICATION
menu.
At the slave BHT to be tested, select “1: SLAVE”, an
master BHT, select “2: MASTER”. Then press the ENT ke
The screen displays as shown on the right during the test, and an infrared
communication test is performed.
If
the screen on the right.
The meanings of the error codes in parentheses are as follo
w
1: The received da
1: 9600
bps
2: 115200 bps
3: 460800 bps
Press
T
o ce of an error.
rmal c
ompletion of t
he test, the tested eps once and
the screen on the right.
e Backspa return to the TEST COMMUNICATION
U slave BHT be
d
P ce/clear k
ey to
m
T