72
BHT-904B/BHT-914B
“1: EAN/UPC”: Detail setting of the EAN/UPC reading
1.
tting screen appears.
Enables or disables reading of the EAN-13/UPC-A.
CTER”:
“3
he first and second characters (country flag) of the
pecified, barcode reading is limited; the barcode for
as the specified
ead. If “?” is specified, reading is carried out without any
PC-A with add-on.
d; the EAN-13/UPC-A
-on is only read. If “OFF” is specified, no limitation is carried
:
“2”: Enables reading of the 2-digit add-on.
(EAN-8 setting)
I
Enables
“2: 1ST CHARA
“3: 2ND CHARACTER”:
Sets the first and second characters (country flag) of the EAN-8 to “?, 0 to 9”.
If “0 to 9” is specified, barcode reading is limited for the EAN-8; the barcode for which the first and
second characters are the same as the specified numbers is read. If “?” is specified, reading is
carried out without any limitation. (EAN-8 add-on setting)
“4: READING”:
Enables or disables reading of the EAN-8 with add-on.
“5: ONLY”:
If “ON” is specified, barcode reading is limited; the EAN-8 with add-on is only read. If “OFF” is
specified, no limitation is carried out.
“6: DIGIT”:
“2&5”: Enables reading of the 2-, 5-digit add-on.
“2”: Enables reading of the 2-digit add-on.
“5”: Enables reading of the 5-digit add-on.
[▲] [▼] key
Select “1: EAN/UPC” at the SET BARCODE menu and then press
the ENT key.
The SET EAN/UPC se
EAN/UPC 1/3
(EAN-13/UPC-A setting)
“1: READING”
:
“2: 1ST CHARA
: 2ND CH
ARACTER”:
Sets t
EAN-13/UPC-A to “?, 0 to 9”.
If “0 to 9” is s
w
h
ich the first and second characters are the same
numbers is r
limitation. (EAN-13/UPC-A add-on setting)
“4: READING”:
Enables or disables reading of the EAN-13/U
[▲] [▼] key
“5: ONLY”:
If “ON” is spe
cified, barcode reading is limite
with add
out.
“6: DIGIT”
“2&5”: Enables reading of the 2-, 5-digit add-on.
“5”: Enables reading of the 5-digit add-on.
EAN/UPC 2/3
“1: READ NG”:
or disables reading of the EAN-8.
CTER”:
To Next Page
Loading...
