73
Barcode Handy Terminal
EAN/UPC 3/3
(UPC-E setting)
disables reading of the UPC-E.
“2: 1ST CHARACTER”:
Sets the first and second characters (country flag) of the UPC-E to “?, 0 to 9”.
specified, barcode reading is limited for the UPC-E; the
the same as the specified numbers is read.
hout any limitation. (UPC-E add-on setting)
“4
ading of the UPC-E with add-on.
d out.
“6
add-on.
2. Use 6
3. Pre
4. P or Backspace/clear key to update the
m
“1: READING”:
Enables or
“3: 2ND CH
ARACTER”:
If “0 to 9” is barcode for which the first and
If “?” is specified, reading is
on is only read. If “OFF” is
]) to select the desired item.
setting and return to the SET BARCOD
E
second chara
c
ters are
carried out wit
: READING”:
Enables or disables re
“5: ONLY”:
If “ON” is specified, barcode reading is limited; the UPC-E with add-
specified, no limitation is carrie
: DIGIT”:
“2&5”: Enables reading of the 2-, 5-digit add-on.
“2”: Enables reading of the 2-digit add-on.
“5”: Enables reading of the 5-digit
the cursor keys ([▲] [▼]) or numeric keys ([1] [2] [3] [4] [5] [
ss the cursor keys ([◄] [►]) to select the desired setting.
ress the ENT
enu.
To Next Page
Loading...
