77
9 Preset programs
9.1 Firing table for Ceramco 3 metal ceramics (Dentsply Mode)
(Use honeycomb firing material carrier.)
Prog. Firing Preheat Drying Preheat Vacuum- Heating Firing Vacuum Firing Cool
No. program temp. (min) (min) level rate temp. time time stage
(°C) (hPa) (°C/min) (°C) (min) (min)
302 D-C3- 500 05:00 03:00 50 100 975 00:01 00:01 0
Paste opaque
303 D-C3- 650 05:00 05:00 50 70 965 00:01 00:01 0
Powder opaque
304 D-C3- 650 05:00 05:00 50 70 965 00:01 00:01 0
Margin
305
D-C3-Opaque
650 05:00 05:00 50 45 930 00:01 01:00 0
dentine/
Dentine effect/
Dentine
enamel
306 D-C3-Glaze 650 03:00 03:00 0 45 920 00:00 03:00 0
without
Glaze liquid
307 D-C3- 650 03:00 03:00 0 55 925 00:00 00:30 0
Glaze with mit
Glaze liquid
308 D-C3- 650 05:00 05:00 50 55 920 00:01 00:01 0
Correction
(Add-On)
D = Dentsply Modus
C3 =
Dentsply Ceramco 3-metal ceramic
Firing temperatures are recommendations.
Make a test firing and adjust firing temperatures and times, if required.
For a large number of objects, temperatures or times must be increased appropriately.
To Next Page
Loading...
