English
01
Product Structure
1. Power Button ON / OFF
Hold this button for 2s to power on/off the endoscope
2. Camera LEDs dimmer:
Roll to control the brightness of the camera LEDs
3. WiFi signal indicator:
Blue LED flash: Ready to pair
Blue LED stay on: Connect successfully
4. Power indicator:
Red LED stay on: Power system work normally
Red LED flash: Low battery
Green LED stay on: Charging status
5. Reset Button:
Long press the reset button for about 7 seconds, the device
will shut down, and then restore the factory settings
6. Micro-USB charging port
1
2
5
3
4
6
To Next Page
Loading...
