8555-M512-O1 Rev E y MedVue MV1 Owner’s 15
OPERATION
Basic Operation
To Weigh
1. Press the ON/OFF key to turn the MV1 on.
2. If required, press the ZERO key to zero weight display.
3. Assist patient onto scale.
4. When weight is stable (STABLE [
annunciator will turn on), read weight display.
5. If a printer is connected to scale, press the PRINT key to print a ticket.
6. Assist patient off scale.
Zero Weight Display
1. In Gross Weight mode (GROSS annunciator on), press the ZERO key.
2. Weight display will return to zero. ZERO and STABLE
annunciators will turn on
to show a stable, center-of-zero (Æ0Å) gross weight condition.
Basic Tare Operation
Push Button Tare (Tare weight is NOT known)
NOTE: Tare entry is not allowed if Auto Hold is enabled.
1. In Gross Weight mode (GROSS annunciator on), place item (wheelchair, walker, etc.) on
the scale.
2. Press the TARE key.
3. The Display will change to show ENTER TARE WT, the weight of the item on the scale,
and the TARE annunciator will turn on.
4. Press the ENTER key.
5. Display will change to 0 and NET annunciator will turn on to show that net weight is
being displayed. The item's weight has been entered as "tare weight".
6. Assist patient onto scale.
7. When weight is stable (STABLE
annunciator will turn on), read weight display.
8. If a printer is connected to scale, press the PRINT key to print a ticket.
9. Assist patient off scale.
To Clear the Tare Weight
1. Remove all material from scale platform, and then press the TARE key.
2. Press the ZERO key.
3. This will clear the tare weight and return the MV1 to the Gross weight mode.
ALWAYS assist the patient on and off the scale to ensure they do not fall.
NEVER leave a patient unattended while they are on the scale. Failure to
maintain control of the patient at all times can result in serious injury to the
patient and/or you.
To Next Page
Loading...
Need help?
General