8555-M512-O1 Rev E y MedVue MV1 Owner’s 33
CALIBRATION SETUP, CONT.
(Non- Protected Setup Parameters)
S
With SYSTEM displayed, press the ENTER key. The display will change to LANGUAGE. Proceed
to the LANGUAGE (Language) parameter.
Otherwise, press the ID/HEIGHT key to advance to the
SERIAL PORT menu.
(Language)`
The display will show LANGUAGE and the current setting. If the value displayed is
acceptable, press the ENTER key to save it. Otherwise use the numeric keys to enter a new
value, and then press the ENTER key to save it.
Allowable values are 0, 1, 2, or 3.
0 = En
lish 1= Spanish 2 = French 3 = German
NOTE: The default language is English. Changing the language at this
prompt will change all subsequent prompts and displays to the language
selected.
(Backlight Intensity)`
The display will show bACkLIGHT and the current setting. If the value displayed is
acceptable, press the ENTER key to save it. Otherwise use the numeric keys to enter a new
value, and then press the ENTER key to save it.
Allowable values are 0 through 255.
0 = Backli
ht OFF throu
h 255 = Backli
ht at full intensit
NOTE: The backlight intensity setting will affect battery life. A lower intensity
setting will conserve power and maximize battery operation.
(Allow Keypad Beep)
This setting determines whether the MV1 beeps each time a key is pressed.
The display will show kEYPAd bEEP and the current setting. If the value displayed is
acceptable, press the ENTER key to save it. Otherwise, use the numeric keys 0/NO or 1/YES
to select a new setting, and then press the ENTER key to save it.
Allowable values are YES or no.
YES = The MV1 beeps each time a
key is pressed.
no = MV1 does not beep when a key
is pressed.
To Next Page
Loading...
Need help?
General