51
Remote-Controlled Functions
Remote-Controlled
Functions
The OpenCom 100 enables remote-
controlled calls and remote-pro-
grammable call forwarding. These
features are set up by the adminis-
trator when he configures the sys-
tem. To carry out these features the
system PIN is required.
The system PIN is issued by the sys-
tem administrator, who must
change it from the factory setting
(“0000”) to another value for the
features to function.
Remote-Controlled
Dialling
Without internal number
assignment
Z (reserved tel. no.) Z (system PIN)
(external line seizure code
digit, e.g. )
Z (external tel.
no.)
With internal number
assignment
Z (reserved tel. no.) Z (system PIN)
(external line code digit, e.g.
)
Z (external tel. no.)
Z (internal tel. no.)
Using a telephone number reserved
in the OpenCom 100 for this pur-
pose, you can call an external tele-
phone number from another exter-
nal telephone, and thus get the
benefit of different tariff zones, for
example. In addition, the number re-
served in the OpenCom 100 can also
be assigned an internal telephone
number via which the dialling is to
be performed. In the case of remote-
controlled dialling, there is no check
on authorisation and LCR is not used.
Remote-Programmable
Call Forwarding
Configuring the function
Z (reserved tel. no.) Z (system PIN)
Z (your internal tel. no.)
(external line code digit, e.g.
)
Z (destination tel. no.)
Deleting the function
Z (reserved tel. no.) Z (system PIN)
Z (your internal tel. no.)
Using the telephone number re-
served in the OpenCom 100 for
remote control, you can configure
op6365_gb.book Seite 51 Mittwoch, 28. August 2002 11:09 11
To Next Page
Loading...