60
Main Menu Features and MenuCards
MenuCard
“Phone settings”
1ƒVolume
: Select
1 Loudspeaker
or
2 Handset
. You can change the
default volume by using the
key or entering a digit from
to .
2 Ring tone
: You can configure
the ring tones for incoming calls on
your telephone collectively or indi-
vidually. You can specify whether a
ring tone is to apply to the entire ter-
minal or whether calls to particular
call keys are to be signalled in differ-
ent ways.
If keys on your telephone are as-
signed, you either select
All
, or, for
individual settings, you select a key
from the list of currently configured
call keys.
You can use different melodies and
volumes to distinguish between four
types of incoming calls:
–
1 External calls
–
2 Internal calls
–
3 VIP call
–
4 Door call
You can set the
1 Volume
and the
2 Melody
individually for each type
of call. Select a setting and edit it
with the key, or enter a digit
….
In the OpenCom 100 you can also
configure melodies in addition to
the existing ones, e.g. for calls via
the OpenCTI 50.
Note: In the Configurator of the
Web console you can use the option
Dialling tones as cadences to spec-
ify whether melodies are to be played
in full or whether they are all to be
made the same length.
4ƒMessage ring tone
: You can
set different ringer signals to signal
messages on your system telephone
or calls for members of your pick-up
group. These can then be distin-
guished from one another.
If the feature is active, select
1 Short messages,2 E-mail
,
3 Pick-up
or
4 Voicebox
. For
each type of message, you can spec-
ify
1 Volume
and
2 Melody
, or a
short beep tone instead of a melody.
The short beep tone is the default
setting for all messages. When con-
figuring the OpenCom 100, your sys-
tem administrator can determine
whether calls for the members in
your pick-up group are indicated on
your display as well.
5ƒEn-Bloc dialling
: This
switches your telephone to auto-
matic dialling (
On
) or direct dialling
(
Off
).
6ƒCharge settings
: If your net-
work operator transmits the call-
charge data, you can display them
(
Charge
), switch to
Duration
(call
time indication) or switch the charge
display off (
Off
).
op6365_gb.book Seite 60 Mittwoch, 28. August 2002 11:09 11
To Next Page
Loading...
