DeVilbiss 5-Liter Oxygen Concentrator User Manual (English)

Questions and Answers:

J
Judith DanielAug 5, 2025
What to do if the DeVilbiss Medical Equipment unit does not operate and all lights are off?
- D
  Danielle GrahamAug 5, 2025
  If your DeVilbiss Medical Equipment unit isn't working, and all the lights are off while the power switch is on and the alert is pulsing, there might be a few reasons. First, ensure the power cord is properly inserted into the wall outlet, and check the mains connection on the back of the unit if it's a 230-volt model. Second, check your home circuit breaker and reset it if needed. If the issue continues, try a different wall outlet. Finally, press the concentrator circuit breaker reset button located below the power switch. If none of these steps work, contact your DeVilbiss provider.
G
gracesmithAug 9, 2025
Why is the red service required light on my DeVilbiss Medical Equipment?
- G
  gwendolyn15Aug 9, 2025
  If the red service required light is illuminated on your DeVilbiss Medical Equipment, and an audible alert is sounding, there are several potential causes. Check the air filter and wash it if it's dirty. Ensure that nothing is blocking the exhaust area of the unit. Inspect the cannula, face mask, or oxygen tubing for blockages or defects; detach them to see if proper flow is restored, and clean or replace them if necessary. Also, detach the humidifier to check for proper flow, cleaning or replacing it if needed. Finally, ensure the flow meter is set to the prescribed flow rate. If these steps do not resolve the issue, contact your DeVilbiss provider.
D
Dawn GriffithAug 13, 2025
What to do if the yellow low oxygen light is on for DeVilbiss Medical Equipment?
- M
  Michael FowlerAug 13, 2025
  If the yellow Low Oxygen light is on, your DeVilbiss Medical Equipment might be in 'start up' mode. Allow the unit up to 15 minutes to complete this start up period.
M
Matthew ClarkAug 18, 2025
What to do if the red service required light is on and an intermittent audible signal is sounding on my DeVilbiss Medical Equipment?
- D
  Danielle BrownAug 18, 2025
  If the Red Service Required light is on and an intermittent audible signal is sounding on your DeVilbiss Medical Equipment, check the following: * Ensure the flow meter is properly set to the prescribed number. * Check the air filter and clean it if it's dirty. * Check the exhaust area to ensure nothing is blocking it. If the above remedies do not work, and if you suspect an Electronic Assembly Malfunction, turn your unit off, switch to your reserve oxygen system, and contact your DeVilbiss provider immediately.
M
Michael SmithAug 22, 2025
What to do if the yellow low oxygen light is on and the intermittent audible signal is sounding on my DeVilbiss Medical Equipment?
- D
  Daniel SmithAug 22, 2025
  If the yellow Low Oxygen light is on and an intermittent audible signal is sounding on your DeVilbiss Medical Equipment, ensure the flow meter is properly set to the prescribed number. Also, check the air filter and wash it if it is dirty. Finally, check the exhaust area and make sure there is nothing restricting the unit exhaust. If these steps do not resolve the issue, contact your DeVilbiss provider.
P
pamelasanchezAug 27, 2025
Why does my DeVilbiss Medical Equipment make a low-frequency vibration sound?
- S
  Scott FordAug 27, 2025
  If your DeVilbiss Medical Equipment is making an audible low-frequency vibration sound, it could be due to an Electronic Assembly Malfunction. In this case, turn your unit off, switch to your reserve oxygen system, and contact your DeVilbiss provider immediately.
H
Heidi EvansAug 31, 2025
What should I do if any other problems occur with my DeVilbiss oxygen concentrator?
- L
  Laura WoodAug 31, 2025
  Turn your unit “Off.” Switch to your reserve oxygen system and contact your DeVilbiss provider immediately.

DeVilbiss 5-Liter Oxygen Concentrator Specifications

General

Oxygen Flow	0.5 to 5 LPM
Oxygen Concentration	93% ± 3%
Weight	36 lbs (16.3 kg)
Outlet Pressure	8.5 PSI
Operating Temperature	41°F to 104°F (5°C to 40°C)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Sound Level	48 dBA
Power Consumption	310 W
Dimensions	24.5 in (62.2 cm) H x 13.5 in (34.2 cm) W x 12 in (30.4 cm) D
Operating Altitude	Up to 8, 000 ft (2, 438 m)
Operating Humidity	15% to 95% (non-condensing)
Alarms	Power Failure, High/Low Pressure, Low Oxygen