The product may be cleaned using a gun washing machine.
Do not use or store below 32°F [0°C] or above 105°F [40°C].
The digital gauge is not designed for use with highly corrosive and/or abrasive materials.
To avoid premature degradation of parts, DeVilbiss recommends that the digital gauge is
washed in neutral cleaning solution [pH 6 to 8].
If there is any doubt regarding the suitability of a specific material, contact your DeVilbiss Distributor
or DeVilbiss direct.
The gauge must be connected to a hose made from a conductive material and must be
connected to earth with a resistance of less than 1MΩ to minimise the risk of static electricity
from air and/or fluids passing through it.
Exceeding this may result in injury to the user.
The maximum static inlet pressure of 100 psi [7 bar] must not be exceeded (see specification).
Use only spares and accessories as detailed in this bulletin.
The digital gauge is not designed to be cleaned within an ultrasonic bath.
The fitting of non-original spares may create hazards.
However, please consult with the manufacturer on suitability.
If the gauge is physically damaged under any circumstances, stop using immediately,
if the plating is damaged and exposes the base metal, do not use in a hazardous (zoned) area.
The digital gauge is suitable for use with both waterbased and solvent based coating materials.
Do not attempt to dismantle or service the gauge.
When the battery is discharged, the complete gauge assembly must be replaced.
The battery is not replaceable.
Do not attempt to dismantle the gauge under any circumstances.
SB-E-9-224 R1.0
6/8
www.carlisleft.com
To Next Page
Loading...
