DeVilbiss Intellipap DV5HH - Page 21


DisplayExample Description Mode
SetPressure
10.0cmH2O
This is a prescription setting which controls the operating pressure. CPAP
Mode
DelayTime 
45minutes
Selectable delay time setting. Your provider has set the delay time. All
DelayPressure
5.0cmH2O
This is a prescription setting which controls the operating pressure during
the delay time.
CPAP
Mode
TubingLength 
1.8m(6ft)
The standard tubing length supplied with the device is 6 feet (1.8 meters).
However, you can adjust your device to accommodate an air supply tubing
length of 10 feet (3.0 meters). Replacement tubing can be obtained through
your home care provider (part numbers listed at the end of this manual).
All
SmartFlexMenu
Press
Pressing the down key enters the SmartFlex menu. Refer to SmartFlex
Menu section for details
All
EnableMenu
Press
Pressing the down key enters the Enable menu. Refer to next section for
Enable Menu details.
All
LCDContrastAdj
50%
This setting changes the contrast for the LCD display. This only needs to
be adjusted if you nd it difcult to see the display from your viewing angle.
All
ComplianceMeter
123456.7hours
The total number of hours (in 1/10 hour increments) that the device has
been providing therapy.
All
Hourmeter
HD123456
The total number of hours (in 1/10 hour increments) that the device has
been in operation.
FirmwareVersion
V0.1921/08/2009
Shows version of installed rmware. All
SerialNumber
HD123456
Shows the serial number of the device. All
AdherenceScore
83%(25/30)
Shows the maximum adherence achieved for any period of thirty
consecutive days of use within a ninety-day time frame. The score
represents the percentage of days, within thirty consecutive days, where
usage met or exceeded the ‘Usage Threshold.’
All
SmartCode 1-Day
F6CD-37F-357R
SmartCode 7-Day
3CCC-377D-7J7X
SmartCode 30-Day
DWY4-3DB7-DJ7L
SmartCode 90-Day
752TT-47DB-7DT7C
SmartCode Usage
ZDN-79FK-K7H
SmartCode data is used for therapy management reporting; therapy
information is encoded in a series of letters and numbers, and includes a
special character for error checking to ensure accuracy. Use the UP arrow
or DOWN arrow keys to change the SmartCode reporting period. There
are ve levels of SmartCode data – 1-day, 7-day, 30-day, 90-day and
Usage. Use UP or DOWN button to change between levels.
All
NOTE
