DeVilbiss SRi PRO Lite - Technical Specifications; Air Inlet Pressure Specifications

EN
P1 =
WITH CUP
455g
395g
Stainless Steel, HDPE
L x H x W mm
Air Cap
Nickel plated brass
AIR INLET PRESSURES
ENVIRONMENTAL
Max Ambient Operating Temperature
MATERIALS OF CONSTRUCTION
12 bar [175 psi]
Gun Air Inlet Pressure for High Efficiency and HVLP setups, with gun
triggered.
2.0 bar [29 psi]
40°C Nominal [104°F]
FUNCTIONAL DESCRIPTION
SPECIFICATIONS
Fluid Tip, Fluid Needle and Trigger Stud
GUN WEIGHT
Air Inlet, Body Bushing, Spreader Valve Body, Air Valve Nut
Chrome plated brass
Stainless Steel
Solvent resistant
Chrome plated steel
The SRi PRO Lite spray gun is a professional quality gun designed with EPA compliant, high efficiency or high
volume, low pressure (HVLP) technology. HVLP technology reduces overspray and limits air cap pressure to 0.7
bar (10 psi). High efficiency complies with EPA by obtaining transfer efficiency above 65%.
IMPORTANT: This spraygun is suitable for use with both waterbased and solvent based coating materials. The
gun is not designed for use with highly corrosive and/or abrasive materials and if used with such materials it
must be expected that the need for cleaning and/or replacement of parts will be increased. If there is any doubt
regarding the suitability of a specific material, contact your DeVilbiss Distributor or DeVilbiss direct.
Gun Body, Air Cap Retaining Ring, Knobs
Anodised aluminium
Stainless Steel
Springs, Clips, Screws
Seals, Gaskets
Trigger
Max Static Air Input Pressure
GUN ONLY
Air Valve Assembly
DIMENSIONS (See page 21)
Fluid Inlet Size
7/16" - 14 UNC
135 x 252 x 18
CONNECTIONS
Universal 1/4" BSP and 1/4" NPS male
Air Inlet Size
SB-E-2-512 R2.0
2/24