DeVilbiss SRi PRO Lite - Troubleshooting Mechanical Issues; General Spraying Problems; Fluid Tip and Air Cap Issues

EN
Replace with new fluid tip.
Replace with new needle.
Excessive needle wear.
Excessive fluid tip wear.
No air pressure at gun.
Open fluid needle adjustment
knob.
Check air supply and air line.
Will not spray.
Fluid needle adjustment knob not
open enough.
Check fluid tip/needle selection
chart and fit correct item.
Gun spits paint when triggering
on and off.
Unable to get round spray
Remove, check components for
damage and refit correctly.
Fluid tip/needle leakage.
Paint build-up on fluid tip.
Fluid tip not fitted correctly in
gun head.
Tighten.
Fluid tip/needle leakage.
Check for damage or blockage.
Damaged air cap holes.
Replace with new air cap.
Gradual build-up of bounce-back
on gun head.
Thoroughly clean.
Check for damage or blockage.
CORRECTION
Fluid tip not fitted correctly in
gun head.
Tighten.
GENERAL FAULTS
CAUSE
TROUBLESHOOTING MECHANICAL PERFORMANCE
Fluid tip or sprayhead incorrectly
fitted.
Paint build-up on air cap.
Gun spits paint when triggering
on due to paint build-up inside air
cap between spraying operations.
Incorrect needle fitted to gun.
SB-E-2-512 R2.0
15/24